Manipulator Labels - Epson E2C Series Manipulator Manual

Setup & Operation 1. Safety

1.6 Manipulator Labels

The following labels are attached around the locations of the Manipulator where specific
dangers exist.
Be sure to comply with descriptions and warnings on the labels to operate and maintain
the Manipulator safely.
Do not tear, damage, or remove the labels. Use meticulous care when handling those
parts or units to which the following labels are attached as well as the nearby areas:
Location of Labels
Table Top
Gap gauge for adjusting brake clearance
(Inside of the arm top cover)
8
Multiple Mountings
NOTE:
Hazardous voltage exists while the
Manipulator is ON. To avoid electric
shock, do not touch any internal electric
parts.
NOTE:
You will catch your hand or fingers between the shaft and
cover when bringing your hand close to moving parts.
Labels
NOTE:
Before unscrewing the
base mounting screws,
hold the arm and secure
it tightly with a band to
prevent hands or fingers
from being caught in the
Manipulator.
E2C Rev.6