Standalone Commands; T (Time) Command - Honeywell NetAXS NX4L1 Installation Manual

Access control unit

Hide thumbs Also See for NetAXS NX4L1:

Table of Contents

3.0 Standalone Commands

CAUTION

the NetAXS™ panel.

1. T command: Sets the panel's time

2. D command: Sets the panel's date

3. L command: Creates time zones for use by the cards

4. C command: Adds or deletes cards from the panel

5. W command: Program each input for either NO/NC and supervised or

non-supervised operation

6. P command: Sets interlocks between input points and/or output points

In all examples, the underscore character "_" indicates a space and <CR>

Note:

indicates a carriage return.

_T=pn_hh:mm<CR>

Variables:

pn = panel number (1–31)

hh = hours (0–23) (Military time)

mm = minutes (00–59)

Example 1

_T=1_08:30<CR>

This command would set panel 1 to a time of 8:30 AM.

Example 2

_T=6_18:15<CR>

This command would set panel 6 to a time of 6:15 PM.

NetAXS™ NX4L1 Access Control Unit Installation Guide, Document 7-901099V3

Use the following commands, in the order they are listed, to configure

NetAXS™ Standalone Operation

Standalone Commands

Table of Contents

Show Quick Links

Table of Contents