Underwriters Laboratories Incorporated - Honeywell NetAXS NX4L1 Installation Manual

NetAXS™ NX4L1 Installation Guide
Notices

1.6 Underwriters Laboratories Incorporated

The NetAXS panel was approved by Underwriters Laboratories Incorporated for
Access Control System Units - Category ALVY, UL294 standard. The NetAXS panel
was approved as a standalone system. The input points only monitor the door position.
The NetAXS panel is not intended as a Proprietary Alarm Unit - Category APOU,
UL1076 standard.
The NetAXS panel was approved using the following Honeywell readers:
OmniAssure™ OT30, OmniClass™ OM40 and OM55, and OmniProx™ OP30 and
OP40.
Notes:
• All field wiring, except for the AC power input and the battery backup/charger
wiring, is Class 2 power-limited.
• Communication between panels other than the NetAXS panel has not been
evaluated by UL.
• UL has approved only the configurations shown in
Connection via
NetAXS" on page 43, and
guide. Because UL has approved the NetAXS panel only as a standalone system,
the computer terminal, NetAXS gateway panel, and N-485_PCI-2 adapter appear
in these sections only to illustrate the installation and programming of the
NetAXS panel.
• UL has not evaluated the compatibility of downstream I/O devices (see
4.10, "Downstream
• All wiring methods shall be performed in accordance with NFPA70, local codes
and authorities having jurisdiction.
• This product must be mounted indoors only, installed within the protected
premises.
• This product must be installed, serviced and tested once a year by a factory trained
professional.
• All interconnecting devices must be UL Listed and Class 2 power-limited only.
• The minimum system configuration consists of Model NX4L1 and a Listed,
compatible access control reader or keypad.
• The system shall not be installed in the fail secure mode unless permitted by the
local authority having jurisdiction and shall not interfere with the operation of
panic hardware.
• The model NX4L1 system is capable of providing 40 minutes of standby power.
• The model NX4L1 system is capable of being permanently connected to line
voltage or alternatively a cord connection can be made. The cord shall be a
minimum 6 ft. long and a SJ, SJT, or equivalent.
14
www.honeywell.com
PCI-2" on page 42, Section 5.2, "RS-485 Connection via
Section 5.4, "RS-232
I/O" on page 39) with the NetAXS panel.
Section 5.1, "RS-485
Connection" on page 46 of this
Section