Configuring VTP
Table 6: Default VTP Parameters
Parameters
VTP
VTP Mode
VTP Domain
VTP Version
VTP Pruning
VTP per Interface
Configuring VTP
You can configure VTP on Cisco NX-OS devices.
VLAN 1 is required on all trunk ports used for switch interconnects if VTP is used in transparent mode
Note
in the network. Disabling VLAN 1 from any of these ports prevents VTP from functioning properly in
transparent mode.
Before Cisco NX-OS Release 5.1(1), VTP worked only in transparent mode. With Cisco NX-OS Release
Note
7.2(0), VTP version 3 was introduced.
Before You Begin
Ensure that you are in the correct virtual device context (VDC) (or enter the switchto vdc command). VLAN
names and IDs can be repeated in different VDCs, so you must confirm which VDC that you are working in.
Cisco Nexus 7000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.x
Configuring VTP
Default
Disabled
Transparent
blank
1
Disabled
Enabled
47