Table of Contents
Advertisement
K-750R
2. Remove the bolt anchoring the pigtail. It is located on
the back of the drum (Figure 12) .
Figure 12 – Removing Pigtail Anchoring Bolt
3. Remove the pigtail from drum by pulling it through the
guide tube.
4. Insert new pigtail by pushing it through the guide
tube into the drum.
5. Align hole in pigtail fastener with the hole in the back
of the drum. Insert bolt, washers and nut and tighten
securely. Push the remainder of the pigtail into drum.
Accessories
Only the following RIDGID products have
WARNING
been designed to function with the K-750R Drain Cleaning
Machine. Other accessories suitable for use with other
tools may become hazardous when used on the K-750R.
To prevent serious injury, use only the accessories listed
below.
Catalog
Model
No.
No.
Description
" x 100' Solid Core Cable
87602
C-24 IW
5
/
8
92485
T-403
P-Trap Cutter
92495
T-406
Spade Cutter
92510
T-411
2" Cutter
92520
T-413
3" Cutter
92525
T-414
4" Cutter
41937
—
Gloves
59360
—
Toolbox
43642
A-75
AUTOFEED Assembly
59982
—
Cable Rust Inhibitor, 1 Quart
59987
—
Cable Rust Inhibitor, 1 Gallon
10
5
/
" Cage Machine
8
Maintenance Instructions
WARNING
Make sure machine is unplugged from power
source before performing maintenance or making
any adjustments.
Lubrication
Grease all exposed, moving and rotating parts as required.
Grease drum assembly fitting periodically.
Cables
Drain drum after every use. Flush drum periodically,
remove sediment that can corrode cable.
Cables should be thoroughly flushed with water to pre-
vent damaging effects of drain cleaning compounds.
Periodically lubricate cables and couplings with RIDGID
Cable Rust Inhibitor. See accessories regarding catalog
numbers.
When not in use, store cables indoors to prevent deteri-
oration by the elements.
Cables should be replaced when they become severely
corroded or worn. A worn cable can be identified when
outside coils of cable become flat.
Machine Storage
Motor-driven equipment must be kept
WARNING
indoors or well covered in rainy weather. Store the
machine in a locked area that is out of reach of children
and people unfamiliar with drain cleaners. This machine
can cause serious injury in the hands of untrained users.
Service and Repair
Service and repair work on this Drain Cleaner must be
performed by qualified repair personnel. Machine should
be taken to a RIDGID Independent Authorized Service
Center or returned to the factory. All repairs made by
Ridge service facilities are warranted against defects
in material and workmanship.
When servicing this machine, only iden-
WARNING
tical replacement parts should be used. Failure to follow
these instructions may create a risk of electrical shock or
other serious injury.
Advertisement
Table of Contents
