AEG BMG 4906 Instruction Manual & Guarantee page 78

AEG_BMG_4906_BedAnl_80x80_3.qxd
GB
Description of the symbols on the display
♥
The symbol
finished.
Measuring error: EE and RETEST will be displayed if the blood pressure
could not be measured exactly. Wait until the display mode 0 0 (fig. A)
appears again. The cuff must be wrapped around the wrist as described in
the Operating Instructions. Relax your hand. Do not move or talk during mea-
suring. Pay attention to the correct posture.
Measuring instructions
A. Setting date and time
a Keep pressed the MODE button for a while („Month" (M) starts flashing).
Use the – or + button to set the correct month (1, 2, 3, ... 12).
b. Push the MODE button again – 'Day' (D) starts to flash.
Use the – or + button to set the correct day.
Repeat the above steps to set the correct time (hours, minutes). Finish
the setting procedure by pushing the MODE button again.
B. Measuring blood pressure
a. Wrap the cuff around your wrist (see sec-
tion 'Putting on the cuff').
b. Sit down on a chair and take up an upright
position (see section 'Correct body position
for measuring').
c. Keep pressed the START button for approx.
2 seconds in order to switch on the device.
78
is flashing during the whole time until the measurement is
19.02.2008 17:35 Uh