Error Messages; Warning Messages - Yamaha DME4io-ES Service Manual

DME4io-ES/DME8i-ES/DME8o-ES

ERROR MESSAGES

Indicator
Flashing
PEAK
Lit
SIGNAL
PEAK
SIGNAL
Flashing
PEAK
Lit
SIGNAL
PEAK
SIGNAL
PEAK
Lit
SIGNAL
PEAK
SIGNAL
PEAK
Lit
SIGNAL
PEAK
SIGNAL
PEAK
Lit
SIGNAL
PEAK
SIGNAL
Flashing
PEAK
Lit
SIGNAL
PEAK
SIGNAL
Flashing
PEAK
Lit
SIGNAL
PEAK
SIGNAL
PEAK
Lit
SIGNAL
PEAK
SIGNAL

WARNING MESSAGES

Indicator
Flashing
rapidly
Flashing
slow
124
Error
A system error has occurred.
PEAK PEAK
SIGNAL SIGNAL L
PEAK PEAK
SIGNAL SIGNAL
Data inside the internal flash
memory has been erased.
PEAK PEAK
SIGNAL SIGNAL
PEAK PEAK
SIGNAL SIGNAL
The internal battery is
Flashing
completely discharged or not
installed.
PEAK PEAK
SIGNAL SIGNAL
PEAK PEAK
SIGNAL SIGNAL
A scene recall attempt has
Flashing
failed.
PEAK PEAK
SIGNAL SIGNAL
PEAK PEAK
SIGNAL SIGNAL
Audio is not input or output and
PEAK PEAK
is muted due to insufficient DSP
SIGNAL SIGNAL
resources.
PEAK PEAK
SIGNAL SIGNAL
The network is not
PEAK PEAK
communicating properly.
SIGNAL SIGNAL
PEAK PEAK
SIGNAL SIGNAL
Duplicate IP addresses.
PEAK PEAK
SIGNAL SIGNAL
PEAK PEAK
SIGNAL SIGNAL
Flashing
The DME Satellite contains data
PEAK PEAK
for a different device group or
SIGNAL SIGNAL
no data.
PEAK PEAK
SIGNAL SIGNAL
Flashing
The internal battery is almost
PEAK PEAK PEAK
discharged. Your data may be
SIGNAL SIGNAL SIGNAL
lost.
PEAK PEAK PEAK
SIGNAL SIGNAL SIGNAL
The backup battery voltage is
PEAK PEAK PEAK
low.
SIGNAL SIGNAL SIGNAL
PEAK PEAK PEAK
SIGNAL SIGNAL SIGNAL
Execute the "Initialize DME" operation, then restart it. If the error
indicators are still indicating the error, execute the "Delete All Data"
initialization.
The firmware update operation may have failed. Use DME Designer
to execute the Recovery update operation.
If you turn off the power to the unit, the current settings will be lost
and reset to the default values. Stop operating the unit.
Use DME Designer to recall the scene again.
This error sometimes occurs if you try to operate a configuration at
96 kHz that has been created with a word clock of 48 kHz. To
operate a configuration at any word clock setting, use DME Designer
to create a configuration with the word clock set to 96 kHz.
Connect the Ethernet cables properly, and make sure that the
network devices are operating correctly.
Connect your computer to the DME Satellite via USB, then set a
unique IP address.
Send data appropriate for the actual device configuration from DME
Designer.
Error
If you turn off the power to the unit, the current settings may
be lost and reset to the default values.
This does not affect the operation of the unit. However, if you
continue using the unit, the settings may be lost and reset to
the default values.
Action
Action
Stop operating the unit.