Shutdown - Epson TP3 Manual

Update
(1) Insert the USB memory to the USB port (lower) on the Teach Pendant.
(2) After the USB memory is recognized, tap the <Upgrade> button of [Configuration]
(3) After the confirmation window is displayed, tap the <OK> button and start update.
Update will complete in a few minutes.
To remove the USB memory, tap the <Unmount> button and follow the instruction.
The current version can be checked in [System Information] - [Terminal device
information] - [Software Version].
Reference: Operation 5.3.2 System Information
Do not remove the Teach Pendant power cable and USB memory while updating
■
software.
Teach Pendant and USB memory may be damaged.
CAUTION
Do not operate the robot while updating software.
■
The software may be damaged and the system may not start.
For details of cautions for using the USB memory, refer to Operation 8. USB Port.

5.3.4 Shutdown

In this panel, you can shut down the Teach Pendant system.
Tapping the <Execute> button starts shutdown processing.
The following operations stop power supply to the Teach Pendant. Before conducting
the following operations, make sure to shut down the Teach Pendant system.
RC700-A option TP3 Rev.8
panel.
When turning off the Controller
When removing the Teach Pendant from the Controller
Operation 5. AUTO Mode
83