Sanyo LNS LNS-W03 Installation Procedures Manual page 6

4
DISCONNECT THE LENS SHIFT CONNECTORS. (See figure-4)
Disconnect the Lens Shift Connectors
("K96S" and "K96R") from circuit board.
5 INSTALL THE LENS. (See figure-5)
1. Remove protective caps(front and
back) on the lens.
2. Mount the lens on mounting bracket
of the main cabinet with 4 screws.
Use the screws included with the lens.
Use the driver included with the lens to
fasten the screws.
(After using, keep it for latter use.)
6 INSTALL THE LIGHT-BLOCK SHEET. (See figure-6)
Install the light-block sheet around the lens
as shown in the illustration. Use the sheet
included with the lens.
Make sure the part no. and mark (TOP and
BACK) on Light-Block Sheet and set them
properly.
ADJUST FOCUS
Adjust focus following Focus Adjustment on
page 6.
CONNECTOR
"K96S"
ATTACHED DRIVER
LIGHT-BLOCK SHEET
Type FB1
(Part No. 610 285 8211)
-5-
LEAD
HOLDER
CONNECTOR
"K96R"
LENS MOUNTING BRACKET
Fig-4
Fig-5
Fig-6