Sanyo LNS LNS-W03 Installation Procedures Manual page 5

LENS REPLACEMENT AND INSTALLATION PROCEDURE
Perform the steps
First set the lens at the center position with lens shift adjustment.
1
REMOVE THE UPPER LENS COVER. (See figure-1)
1. Remove screws A (2 screws).
2. Push part B and pull Upper Lens Cover up.
2 REMOVE THE LOWER LENS COVER. (See figure-2)
1. Remove screws C (4 screws).
2. Pull Lower Lens Cover toward front and
remove.
3 REMOVE THE COVER PLATE. (See figure-3)
1. Remove screws D (2 screws) and Cover
Plate on the back of Upper Lens Cover.
(At the step , insert the light-block sheet in
6
the same position as the removed cover plate
has been placed. Two screws are not used.)
1 7
to for lens replacement and installation.
UPPER LENS
COVER
B
LOWER LENS
COVER
COVER PLATE
-4-
(Type 2 Cabinet)
A
Fig-1
C
C
Fig-2
D
UPPER LENS
COVER
Fig-3