Download
Share
Print this page
Sanyo LNS LNS-W03 Installation Procedures Manual
  1. Manuals
  2. Brands
  3. Sanyo Manuals
  4. Projector Accessories
  5. LNS LNS-W03
  6. Installation procedures manual

Sanyo LNS LNS-W03 Installation Procedures Manual

Lcd projector lens
Hide thumbs Also See for LNS LNS-W03:
1
2
3
4
5
6
7

Advertisement

Quick Links

Download this manual
LCD PROJECTOR LENS
MODEL NO. LNS-W03
LENS REPLACEMENT
AND INSTALLATION PROCEDURES
NOTES ON REPLACEMENT AND INSTALLATION
The procedures and the needed pars for lens installation depend on the type of
cabinet. Before installing or replacing the lens, make sure the type of cabinet and be
sure to refer to the Installations corresponding with your projector.
When installing or replacing the lens, make sure the Lens Model No. matches with
your projector. Refer to the catalog, or contact your sales dealer for the proper Lens
Model No.
TYPE OF THE CABINET AND INSTALLATION PROCEDURES
Refer to the Installation procedure corresponding to your projector and install the lens
correctly. (See the chart below.)
Type of the Cabinet (1) See Page 2
For use the other models (other than above cabinet), contact your sales dealer.
Type of the Cabinet (2) See Page 4
1AA6P1P2952-- (ICYZ)

Advertisement

loading

Related Manuals for Sanyo LNS LNS-W03

Summary of Contents for Sanyo LNS LNS-W03

  • Page 1 LCD PROJECTOR LENS MODEL NO. LNS-W03 LENS REPLACEMENT AND INSTALLATION PROCEDURES NOTES ON REPLACEMENT AND INSTALLATION The procedures and the needed pars for lens installation depend on the type of cabinet. Before installing or replacing the lens, make sure the type of cabinet and be sure to refer to the Installations corresponding with your projector.
  • Page 2 NOTES ON LENS INSTALLATION The ZOOM, FOCUS and LENS SHIFT adjustment on the Top Control or the Remote Control cannot be operated with this Lens. • Lens installation and replacement should be made by the qualified service per- sonnel. • Be sure to install the lens following this procedure precisely. •...
  • Page 3 LENS REPLACEMENT AND INSTALLATION PROCEDURE Perform the steps First set the lens at the center position with lens shift adjustment. REMOVE THE LENS COVER. (See figure-1) 1. Remove screws A (2 screws). 2. Pull down the lower lens cover while pushing the part D, then remove it.

  • Page 4: Adjust Focus

    INSTALL THE LENS. (See figure-4) 1. Remove protective caps(front and back) on the lens. 2. Mount the lens on mounting bracket of the main cabinet with 4 screws. Use the screws included with the lens. Use the driver included with the lens to fasten the screws.
  • Page 5 LENS REPLACEMENT AND INSTALLATION PROCEDURE Perform the steps First set the lens at the center position with lens shift adjustment. REMOVE THE UPPER LENS COVER. (See figure-1) 1. Remove screws A (2 screws). 2. Push part B and pull Upper Lens Cover up. REMOVE THE LOWER LENS COVER.
  • Page 6 DISCONNECT THE LENS SHIFT CONNECTORS. (See figure-4) Disconnect the Lens Shift Connectors ("K96S" and "K96R") from circuit board. INSTALL THE LENS. (See figure-5) 1. Remove protective caps(front and back) on the lens. 2. Mount the lens on mounting bracket of the main cabinet with 4 screws. Use the screws included with the lens.

  • Page 7: Focus Adjustment

    MOUNT THE LENS COVER. (See figure-7) 1. Replace Lower Lens Cover. Slide Light-Block Sheet into the guide of Lower Lens Cover and set them in front of the flap. (See Fig. 7.) Fix Lower Lens Cover with 4 Screws C. (See Fig.