Grizzly Extreme Series Owner's Manual page 20

9.
Attach lever board to bandsaw body with (4)
spacers and (4) M8-1.25 x 60 cap screws, as
shown in Figure 10.
Figure 10. Lever body attached.
10. Thread four set screws into lever board from
underneath until they are flush with top of
lever board (see Figure 11), then thread
M8-1.25 hex nuts up set screws and against
lever board.
Note: The hex nuts act to lock the set screws
in place once they are positioned, so they do
not vibrate loose during operation.
Set Screws Flush w/Top
Figure 11. Set screws installed in lever board
(3 of 4 shown).
11. Attach extension table to lever board with (4)
M6-1 x 25 cap screws, (4) 6mm flat washers,
and (4) 6mm lock washers (see Figure 12).
Only thread cap screws in halfway for now
(adjustments to extension table will be made
later).
-18-
Figure 12. Extension table installed.
12. Remove table insert from center of table and
remove table pin from end of table slot.
13. Fit table around blade and rest table trun-
nions on trunnion base, making sure trunnion
bolts are hanging out of bottom of trunnion
base.
14. Thread (2) M10-1.5 knobs onto the trunnion
bolts hanging through bottom of trunnion
base, as illustrated in Figure 13.
Table
Figure 13. Table installation on trunnion base.
15. Place table insert in center of table, so it sits
flush with table top surface.
16. Insert pin into end of table slot.
G0555X (Mfd. Since 9/17)
Table Trunnion
Trunnion Base
Trunnion Bolt