Installing the Front Splash Guards
5.
Turn the steering wheel fully counterclockwise.
LEFT FRONT
INNER FENDER
FRONT
6.
Remove two screws from the left front inner fender.
7.
Using a pushpin, pierce the center of two clips on the
left front inner fender.
LEFT FRONT
INNER FENDER
FRONT
© 2013 American Honda Motor Co., Inc. – All Rights Reserved.
2 SCREWS
QC11403AY
2 CLIPS
PUSHPIN
QC11404AY
8.
Secure the left front splash guard to the left front
inner fender with one 5 x 25 mm self-tapping screw
and three screws removed step in 1 and step in 6.
While holding the splash guard firmly against the
fenderwell, tighten the self-tapping screw and
screws in the order
NOTE: Check for a gap between the splash guard
and the body. If a gap exists, loosen the screws and
repeat the above procedure.
FRONT
2 SCREWS
9.
Turn the steering wheel fully clockwise, and repeat
steps 6 through 8 to install the right front splash
guard.
AII 49542 (1306)
.
LEFT FRONT
INNER FENDER
SCREW
(Reuse from
the rear
fender.)
4
2
3
1
5 x 25 mm
SELF-TAPPING
SCREW
LEFT
FRONT
SPLASH
GUARD
QC11405AY
3 of 3