Advertisement
Quick Links
INSTALLATION
INSTRUCTIONS
PARTS LIST
Front "H" emblem
Rear "H" emblem
Rear "ODYSSEY"
emblem
2 Push nuts
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
Flat-tip screwdriver
Diagonal cutters
Contact cleaner
Shop towel
String
Masking tape
INSTALLATION
NOTE:
•
Be careful not to damage the body finish when you
remove and install the emblems.
•
This emblem kit should be installed only when the
ambient air temperature is 60°F (15°C) or above.
•
To allow the adhesive to cure, do not wash the
vehicle for 24 hours.
© 1999 American Honda Motor Co., Inc - All Rights Reserved.
Accessory
GOLD EMBLEM KIT
P/N 08F20-S0X-100
Installing the Front "H" Emblem
1.
2.
AII 20680 (9908)
Y0540-D
Application
ODYSSEY
Open the hood, and remove the bulkhead cover
(11 expansion clips).
EXPANSION CLIP
BULKHEAD
COVER
Remove the front grille by pulling it toward you (3
expansion clips and 14 retaining tabs). Take care
not to damage the retaining tabs.
FRONT
GRILLE
RETAINING
TAB
Publications No.
AII 20680
Issue Date
AUG 1999
EXPANSION
CLIPS
1 of 3
08F20-S0X-1001-91
Advertisement
Related Manuals for Honda 08F20-S0X-100
Summary of Contents for Honda 08F20-S0X-100
- Page 1 60°F (15°C) or above. • To allow the adhesive to cure, do not wash the vehicle for 24 hours. FRONT GRILLE RETAINING 1 of 3 08F20-S0X-1001-91 © 1999 American Honda Motor Co., Inc - All Rights Reserved. AII 20680 (9908) Y0540-D...
- Page 2 Remove the adhesive backing from the new “H” emblem, and attach it to the front grille. Slide the two new push nuts onto the pins. Reinstall all removed parts. 2 of 3 AII 20680 (9908) © 1999 American Honda Motor Co., Inc - All Rights Reserved.
- Page 3 24 hours to give the adhesive time to cure. CLIP (Remove any original clip(s) that stayed in the body panel.) 3 of 3 © 1999 American Honda Motor Co., Inc - All Rights Reserved. AII 20680 (9908)