Philips CED1800BT Quick Start Manual

Always there to help you
Install / 安裝 / 安装
Register your product and get support at
CED1800BT
Question? Question?
Contact Contact
Philips Philips
Quick Start Guide
快速入門指南
快速入门指南
Install / 安裝 / 安装
Enjoy/ 使用 / 使用
Enjoy/ 使用 / 使用
r
q
p
o
t
n
s
m
l
a
b c d e f g h i j k
English b White strip, black- Front left speaker
edged white strip
Install the car entertainment
c Gray strip, black- Front right speaker
system
edged gray strip
d Purple strip, black- Rear right speaker
Always follow the instructions in this chapter in edged purple strip
sequence.
e Red strip Ignition key +12V DC
These instructions are for a typical installation.
when ON/ACC
However, if your car has different requirements, make
f Blue strip Motor/electric antenna
the adjustment accordingly. If you have any question
relay control lead
regarding installation kits, consult your local retailer.
g White-edged blue Amplifi er relay control
strip lead
Note
h Black strip Ground
•
This system is designed for negative ground (earth) 12V DC i Yellow strip The +12V car battery
operation only.
which is energized at all
• Always install this system in the car dashboard. Other
times
locations can be dangerous as the rear of the system heats
up during use.
•
To avoid short-circuit: before you connect, make sure that
2
the ignition is off.
Connect other wires if necessary. (1-2)
•
Make sure that you connect the yellow and red power supply
leads after all other leads are connected.
• Make sure that all loose leads are insulated with electrical
Caution
tape.
•
Make sure that the leads do not get caught under screws or
• To avoid an accident, the driver must not watch video while
in parts that will move (e.g. seat rail).
driving. By design, this system disallows watching video during
• Make sure that all ground (earth) leads are run to a common
drive. Park your car in a safe place and engage the parking
ground (earth) point.
brake before watching video.
•
Use only the supplied mounting hardware for a safe and
secure installation.
•
I mproper fuses can cause damage or fi re. When you need to
change the fuse, consult a professional. Note
• W hen you connect other devices to this system, make sure
that the rating of the car circuit is higher than the total fuse • W hen the parking brake of your vehicle is not engaged, the
value of all the connected devices. video blocking system is activated. It blocks the display of
•
Never connect speaker wires to the metal body or chassis
front video source only.
of the car. •
If the system is not properly connected with the parking
• Never connect speaker wires with stripes to one another.
brake control module of your vehicle, video signals will be
blocked by the system.
Connect wires
Connectors and External sockets or
sockets on rear panel connectors
Note
1 For ISO male As indicated above
• Make sure that all loose leads are insulated with electrical
connectors
tape.
•
Consult a professional to connect wires as instructed below. 2 REAR OUT R (Red Rear right speaker
•
Before connection, check the car's wiring carefully.
socket)
1 3 AV-IN R (Red socket) Right audio channel
Connect the ISO male connectors. (1-1)
output socket of an
external player
ISO male Connect to
4 AV-IN L (White Left audio channel
connectors
socket) output socket of an
a Green strip, black- Rear left speaker
external player
edged green strip
5 REAR OUT L (White Rear left speaker
socket)