Functional Description - Makita 6922NB Instruction Manual

Class II Construction
revolutions or reciprocation per minute
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Switch action
► 1. Switch trigger
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Removing or installing the outer and
inner sleeves
► 1. Outer sleeve 2. Screw
CAUTION:
• Be careful not to allow foreign matter to enter
the insides of the tool when removing or install-
ing the outer and inner sleeves.
The outer sleeve M20 and inner sleeve 3/4" are factory - installed. If
you need other sizes for your work, replace the sleeves as follows.
Loosen the two screws while holding the outer sleeve. The outer
and inner sleeves will be pushed up by the springs built into the tool.
Press the pin down to remove the inner sleeve from the
1
outer sleeve. Be careful not to drop the inner sleeve
when removing it. Do not remove the inner sleeve
spring, tip rod and tip rod spring from the tool.
► 1. Inner sleeve 2. Pin 3. Outer sleeve
► 1. Tip rod 2. Tip rod spring 3. Inner sleeve spring
4 ENGLISH
1
2
1
2
3
1
2
3