Makita 4341CT Hardware Technical Information page 6

R
epair
5. Assemble stop ring E-3 to pin 4 as illustrated in Fig. 10.
Check, whether slider can reciprocate on linear guide smoothly, or not.
If slider does not reciprocate smoothly, incorrectly assembled linear guides can interfere with slider
in reciprocating. Try again to assemble linear guides correctly.
Linear guide
6. Lubricate the parts assembled in gear housing cover with referring to "< 1 > Lubrication " at page 2.
7. Aligning slider to needle bearing 407 on crank complete, assemble gear housing cover section to gear housing
as illustrated in Fig. 11. Do not forget to assemble packing between gear housing cover and gear housing.
See Fig. 11A.
Slider
Gear housing
cover
Slider
Pin 4
Rod
Needle bearing 407
Align slider to needle bearing 407
on crank complete
4 pcs. of
Tapping screws CT 4 x 16
Safety wire
4341T, 4341CT, 4341FCT
Stop ring E-3
Fig. 10
Crank complete
Balance plate
Gear housing
Fig. 11
Gear housing cover
Packing
Fig. 11A
P 6 / 14