Makita 4341CT Hardware Technical Information page 11

Hide thumbs Also See for 4341CT:

epair

6. Disassemble ball bearing 607 LLB from armature shaft as illustrated in Fig. 35.

< 12 > Assembling armature

< Note in assembling>

1. Do not assemble the used self lock. The self lock has to be always replaced with the fresh one.

2. Pay attention to the assembling direction of self lock and wave washer 6. See Fig. 36

3. The magnet sleeve is installed to the armature shaft on commutator side for sensing the variation of rotating speed.

If it would be damaged, the electronic speed control does not work any more.

So, applying 1R026 " Bearing setting pipe" to self lock, press it with your hand, instead of with arbor press.

Ball bearing 607LLB

Insulation washer

< 13 > Disassembling lever 17 ( for orbital action mode change)

1. With referring to the following section, head cover L and R, and gear housing cover.

"< 4 > Disassembling head cover section section" at page 3"

"< 5 > Disassembling gear housing cover section" at page 4

2. Disassemble stop ring E-5 from the shaft portion of lever 17 with small flat head screwdriver. See Fig. 37.

3. Aligning lever 17 with indication " III ", pull out it from gear housing. Then, cap 5 and compression spring 3

are disassembled. See Fig. 37A.

No.1R269 Bearing extractor

Ball bearing 607 LLB

Stop ring E-5

Align lever 17 with indication " III ".

Fig. 37

Insulation washer

Fig. 35

Self lock

Magnet sleeve

Wave washer 6

Rubber ring 19

Fig. 36

Compression

spring 3

P 11 / 14

Cap 5

Lever 17

Fig. 37A

4341fct