Makita 4341CT Hardware Technical Information page 12

R
epair
< 14 > Disassembling switch rod (4341T, 4341CT, 4341FCT)
1. With referring to "< 11 > Disassembling armature (4341T, 4341CT, 4341FCT)" at page 10, disassemble rear cover.
2. Disassemble the following parts from motor housing. See Fig. 38.
Model No.
4341FCT
4341CT
4341T
3. Disconnect switch rod from switch lever by pulling. Then, switch rod can be disassembled from motor housing.
See Fig. 39.
LED circuit
Switch
Switch block unit
< 15 > Assembling switch rod
1. Insert switch rod into motor housing and align the wide square hole of switch rod with the wide square hole of
motor housing. See Fig. 40 and Fig. 40A.
2. Pressing the switch rod to the wall of motor housing, insert switch lever into the aligned wide square holes as
illustrated in Fig. 38A.
3. Pushing the switch rod to the gear housing side, interlock switch lever with switch rod.
Motor housing
Switch lever
4. Connect lead wire from LED circuit to controller.
Parts to be disassembled
LED circuit, Switch, Switch block unit, Controller
Switch, Switch block unit, Controller
Switch, Switch block unit,
Controller
Wide square hole
of motor housing
Wide square hole
of switch rod
Switch lever
Fig. 38
Press the inserted switch rod
to the wall of motor housing
with aligning the wide square
holes of switch rod to the wide
square hole of motor housing.
Switch rod
Motor housing
Fig. 39
Switch rod
Fig. 40
Switch rod
Fig. 40A
P 12 / 14