Message Codes; Care; Safety Instructions; Areas Of Responsibility - Makita LD080P Manual

Laser distance meter
Hide thumbs Also See for LD080P:
Table of Contents

Advertisement

en

Message Codes

If the message Error does not disappear
after switching on the device repeatedly,
contact the dealer.
If the message InFo appears with a
number, press the Clear button and
observe the following instructions:
No.
Cause
156
Transverse tilt
greater than 10°
162
Calibration mistake Make sure, the device
204
Calculation error
252
Temperature too
high
253
Temperature too
low
255
Received signal too
weak, measuring
time too long
256
Received signal too
high
257
Too much back-
ground light
258
Measurement
outside of meas-
uring range
260
Laser beam inter-
rupted
14

Care

• Clean the device with a damp, soft cloth.
• Never immerse the device in water.
• Never use aggressive cleaning agents
or solvents.
Correction
Hold the instrument
without any transverse
tilt.
is placed on a abso-
lutely horizontal and flat
surface. Repeat the
calibration procedure. If
the mistake still occurs,
contact your dealer.
Perform measurement
again.
Let device cool down.
Warm device up.
Change target surface
(e.g. white paper).
Change target surface
(e.g. white paper).
Shadow target area.
Correct range.
Repeat measurement.
Makita LD080P

Safety Instructions

The person responsible for the instrument
must ensure that all users understand
these directions and adhere to them.

Areas of responsibility

Responsibilities of the manufacturer
of the original equipment:
Makita Corporation Anjo,
Aichi 446-8502 Japan /
Makita, Jan-Baptist Vinkstraat 2, 3070,
Belgium
Internet: www.makita.com
The company above is responsible for
supplying the product, including the User
Manual in a completely safe condition.
The company above is not responsible for
third party accessories.
Responsibilities of the person in
charge of the instrument:
• To understand the safety instructions on
the product and the instructions in the
User Manual.
• To be familiar with local safety regula-
tions relating to accident prevention.
• Always prevent access to the product by
unauthorised personnel.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents