Set The Date And Time; Save The Configuration - Honeywell Domonial CMI Series Installer Manual

Set the date and time

1. On the TCU, press
submenu.
2. Press until DATE & TIME is highlighted, and then
press .
3. Enter the date and then the time using the keypad.
If necessary, press
right and make changes.
Note: The date format is language dependent.
4. Press to save your settings.

Save the configuration

Caution: Do not forget to save your configuration!!
Note: If all the panel LEDs light in succession after saving a configuration, one or more parameters
has been set with an incorrect value. Installation cannot be completed until the values
are corrected.
1. Press several times to highlight SAVE+QUIT.
2. Press .
The SAVE CHANGES message is displayed?.
3. Press .
A PLEASE WAIT message is displayed for a few seconds
before main menu is finally displayed.
4. On the main menu, ensure PROGRAMMING is highlighted,
and then press
5. Using the keypad, type the engineer code,
and then press
The programming options are then displayed.
Follow the next procedure to test the installation.
Page 14 of 52
twice to return to the programming
or to scroll left or
.
.
E
N
G
L
I
S
H
02/2011