Mount, Register And Programme Devices - Honeywell Domonial CMI Series Installer Manual

E

Mount, register and programme devices

N
Take each wireless device in turn to its mounting position, together with the TCU, and then carry
G
out the following procedure for each one.
L
1. Mount the device according to the device's documentation. Do not add the battery
at this time.
I
2. Press
ensure REGISTER is highlighted, and then press
S
The word REGISTERING is displayed on the screen.
H
3. Insert the battery in the device, according to the device instructions.
4. Press the tamper on the device (check the device
instructions, some devices may not have a tamper). The
serial number, type and radio level are displayed on the TCU.
5. Check the radio level. It should be greater than 3 for devices,
and greater than 4 for audio wireless devices.
6. Place the cover on the device, or place the device on its
socket (refer to the device instructions).
7. Press
is optional, we recommend you complete the next step and
apply a meaningful label to the device.
8. Press
remove the default label, type a new label, and then
press
This completes the basic registration of a device, however you can also set the following:

On the MODIFY DEVICE menu, select EDIT to change the device default settings to meet your
system's particular requirements. A list of codes is provided at the end of this manual.

On the MODIFY DEVICE menu, select CHANNEL to change the channel number. This is not
recommended unless specified by your alarm service supplier. By default, channel numbers
are assigned automatically when a device is registered.
Repeat this procedure, as necessary, for all devices in the system.
Page 13 of 52
twice to return to the programming submenu,
to display the MODIFY DEVICE menu. Although it
to select LABEL. Press
.
.
several times to
02/2011