Advertisement
Depress ENTER to scroll until flashing cursor appears under DS (daylight savings mode) in display. To change mode
depress UP or DWN once and ST (standard time mode) will appear in display. Depress ENTER to accept correct
selection. Note: The flashing cursor denotes location of data entry selection to be made. If an entry was made in error or
requires changing, depress SET to backspace, make the correct selection and depress ENTER to accept data and advance
the cursor.
To change or program clock/calendar simply repeat the steps above.
B. Setting Events
Depress ENTER until the flashing cursor appears under OFF in display. Now select type of event required by scrolling
using the UP and DWN push buttons until either ON, OFF, or PL appears in display (ON-Relay ON [latching mode],
OFF-Relay OFF [latching mode], PL-Relay Pulse [momentary]). Depressing ENTER will make selection. When
selecting pulse mode PL01 will appear in display. It is now necessary to assign the length of time (duration of relay
activation). The pulse can range in length from 1 to 15 secondsand is selected using UP or DWN push buttons then
depressing ENTER to accept. Note: If pulse duration is not selected relay output defaults to 1 second. Next, select the
day of the week and time (military) by using UP or DWN and depressing ENTER to accept. You may continue to
program events by repeating the previous steps or exit programming by depressing SET. Note: When programming
additional events it is necessary to select the next consecutive event number following the last event program to continue.
Also, when it is required to have the same event repeated on two (2) or more consecutive days of the week (block
programming), enter the first day followed by the last day by depressing SUN through SAT. Example--Monday through
Thursday, depress MON followed by THURS. For Wednesday through Sunday, depress WED followed by SUN.
C. Setting Block Events (weekly repeat):
A flashing cursor will appear at the location of te first day of the week desired. Depress UP and DWN to delect day.
Depress ENTER to confirm selection, then cursor will appear at the location of the last day of the week desired. Depress
UP and DWN to select day. Depress ENTER to confirm selection. Depress ENTER again to escape.
D. Setting Holiday Events:
Next, select HL to indicate as holiday event and time by using UP and DWN push buttons and depress ENTER to accept.
You may continue to program more holiday events by repeating the previous steps or exit programming by depressing
SET.
4
ENTER to
SET EVENT
Depress SET until
#01^OFF
SU 00:00
Depress ENTER
ENTER to
SET BK
Depress SET until
BK=SA/SU
TIME=DS
Depress ENTER
ENTER to
SET EVENT
Depress SET until
#01^ON
HL 00:00
Depress ENTER
appears in display.
will appear in display.
appears in display.
will appear in display.
appears in display.
will appear in display.
HPT724 Installation Document P/N 52765:A 1/25/06
Continued on next page...
Advertisement
