Cisco TelePresence Touch Installation Manual

Cisco TelePresence Touch
For C Series
iNstALLAtioN guide
78-19948-01 JANUARY 2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
This box contains:
• Cisco TelePresence Touch with cable (7.5 m / 25 ft)
• Power adapter
• Power cable (1.8 m / 6 ft) (included when Touch is shipped as a stand-alone unit)
• Shielded Ethernet cable (5 m / 16 ft)
• Cleaning cloth
Compatibility
The touch screen is used with the Cisco TelePresence Codec C Series. These
codecs are also used in the Cisco TelePresence System Profile series. The touch
screen can be installed in two ways:
A. C onnecting the touch screen to a codec via LAN (local area network).
B. Connecting the touch screen directly to the codec.
Note: The codec software version must be TC4.1 or later.
Safety requirement
You have to use a shielded Ethernet cable (as supplied).
User documentation
User documentation for Cisco TelePresence products, including compliance and
safety information, is found on http://www.cisco.com/go/telepresence/docs.
A
Connecting the touch screen via LAN
The touch screen can be connected to the following codecs via LAN. The codec
may be part of a Profile system.
• Codec C20
• Codec C40
• Codec C60
• Codec C90
Check the system information page on your codec to make sure its software
version is TC4.1 or later. If not, contact your Cisco representative.
1. Restart the codec before you proceed with the installation.
2. Connect the touch screen cable to the Power adapter.
3. Connect the shielded Ethernet cable between the Power adapter and the LAN
(Ethernet) socket.
4. Connect the supplied power cable between the Power adapter and the power
socket. Once power is connected, the touch screen start-up procedure begins.
Wait while the touch screen initializes. Continue when the Select codec to pair
with window appears. This may take a few minutes.
LAN socket
(Ethernet)
5 m
1.8 m
Power
adapter
7.5 m Power socket
Note: The touch screen obtains its IP settings automatically from the network
(DHCP). In most cases this is preferred and you can continue with the pairing.
If you need a static IP address for your touch screen perform the steps described in
the Change the IP settings section, before continuing.
A list of all codecs that are in Pairing mode is displayed on the touch screen.
Refresh list
5. Click the codec name in the list.
Select codec to pair with
Note: If your codec is not in the System name (Codec type)
name@company.com
list, read about What to do if your
Select codec manually...
codec is not listed below.
IP Settings
6. Review codec details and click
System name (Codec type)
Back
name@company.com
Start Pairing to start the pairing
process. Product:
Cisco TelePresence System Codec
SIP URI:
name@company.com
7. If required, the touch screen
H323 id:
downloads and installs new name@company.com
Software:
software from the codec. The
TC4.1.0
touch screen automatically
IP address:
192.168.1.128
restarts after the software
Serial number:
upgrade. This process may take a CBA123456789
few minutes.
Start Pairing
If your codec is password
protected, you will be prompted
for an administrator username
and password to sign in to the
codec.
Continue when the menu and
contact list appear on the touch
screen.
8. Verify that the touch screen is successfully paired to your codec by checking the
codec address displayed in the top banner.
The touch screen is ready to use.
name@company.com
Available name@company.com
The touch screen
menu and contact list
12:00