Technical Specifications; Fcc Statement - Honeywell E529 Product Manual

E529 Product Guide

Technical Specifications

Dimensions
Operating Range
Temperature
Power in

FCC Statement

Rev 2.0 3/20/2017
batteries are completely installed with the right polarities and that the
batteries are not dead. Just after startup the E529 will cycle through RF
Channels 26, 25, 24... all the way to 11 and send a 0x00061 Battery
Powered thermostat exchange message on each RF Channel looking for
a reply from an HVAC thermostat partner with the same Room ID
currently stored in the E529.4G. You will typically not have the HVAC
partner configured yet. Just allow this process to continue until
completion. You will be configuring the actual Room ID and other
required parameters into the E529.4G later.
5. Hook the tabs at the top rear of the E529.4G housing into the matching
depressions at the top of mounting plate and rotate the bottom of the
E529.4G housing toward the wall until it snaps into the place on the
mounting plate. Secure the E529.4G housing to the mounting plate with
the two small screws provided with the E529.4G. The screws thread into
two small holes on the bottom of the E529.4G housing.
Table 7. Technical Specifications
4.7" W x 4.7" H x 1.2" D (119mm x 119nn x 30mm)
41ºF to 149ºF (5ºC to 65ºC)
± 1ºF-60ºF to 85 ºF (±
Four AA Batteries
This equipment has been tested and found to comply with the limits for Class B
digital device, pursuant of part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the guarantee that
interference will not occur in a installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or experienced radio/TV technician for help
•
5ºC-15ºC to 30ºC)
8