Ipv4 Route Table - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
VRF Name
IP Address
Mask
IP Tunnel
Gateway
Null Interface
Backup State
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Delete button to remove the specific entry.

IPv4 Route Table

This window is used to view and configure the IPv4 route table settings.
To view the following window, click L3 Features > IPv4 Route Table, as shown below:
Figure 6-21 IPv4 Static/Default Route Window
Description
Enter the VRF instance name used here. This name can be up to 12
characters long.
Enter the IPv4 address for this route here. Tick the Default Route
option to use the default route as the IPv4 address.
Enter the IPv4 network mask for this route here.
Select the IP Tunnel option to use the IP tunnel feature and enter the
tunnel ID in the space provided. The range of IDs is from 0 to 9999.
Enter the gateway address for this route here.
Select to enable or disable the NULL interface here.
Select the backup state option here. Options to choose from are
Primary, Backup, and Weight.
•
When the Primary option is selected, the route will be used as
the primary route to the destination.
•
When the Backup option is selected, the route will be used as
the backup route to the destination.
•
When the Weight option is selected, the weight number must be
entered with value greater than zero, but less than the maximum
paths number. This number is used to replicate identical route
path (multiple copies) in routing table, so the path get more
chance to be hit for traffic routing. If weight number is not
specified for the static route, the default for the path that exists in
the hashing table is one copy. This value must be between 1 and
32.
183