Russound SIX-SOURCE CONTROLLER CAM6.6 Instruction Manual page 50

INSTALLER
INSTALLATION MENU
2. BANK NAME –
(BnkNm)
CONTROLLR ID (CtlId)
This procedure is used to identify the controller(s) that the tuner will respond to. See Periph Setup -
Flow Chart on page 65
1. Controller:# –
(CtlId)
2. All controllers –
(All)
REGION (Rgion)
This procedure assigns either US or Euro frequency display to the tuner. The difference between the
two is that US FM frequencies operate in .2 MHz increments, while European FM frequencies operate
in .05 MHz increments. See Periph Setup - Flow Chart on page 65
1. US –
(US)
2. EURO –
(Euro)
FACTORY INIT (FInit)
NOTE: This procedure returns the tuner to its factory settings and erases all user settings.
This procedure allows the erasure of all programmed settings and returns them to the factory default
settings. See Periph Setup - Flow Chart on page 65
1. Are you sure? –
(Sure?)
2. Please Wait –
3. Cycle Power –
50
Use the volume up/down keys to select a character and left/right
keys to change a character position. A blinking cursor indicates
placement of the character being entered. Names can be from 1
to 5 characters in length. If adding names from 6-12 characters,
it is suggested you use an optional UNO-S2 keypad.
Select controller ID of controller that will control the tuner.
Select if all controllers in the system can control the tuner.
Select US for US FM frequency display.
Select EURO for EURO FM frequency display.
Confirmation of YES or NO is required to proceed. A NO
selection returns to the top of the Factory Initialization menu.
A YES selection begins the initialization.
Message shows during the initialization process.
When initialization is complete, cycle power to the unit.