Panasonic KX-HNB600 User Manual page 108

Troubleshooting
R If you continue to have trouble performing initial setup, you may be able to configure the hub's Wi-Fi
settings using the WPS feature of your wireless router.
→See "Configuring the hub using your wireless router's WPS feature", Page 108.
Configuring the hub using your wireless router's WPS feature
If you continue to have trouble performing initial setup, you may be able to configure the hub's Wi-Fi
settings using the WPS feature of your wireless router.
Note:
R This procedure requires a wireless router that supports WPS. If your wireless router supports WPS,
make sure the feature is turned on, and locate its WPS button before beginning this procedure. The
WPS button is typically labelled "WPS" or has two curved arrows on it.
R If the hub's LED indicator is lit in yellow, start from step 1. If it is lit in green or red, start from step 5.
1
Disconnect the AC adaptor from the hub.
2
While pressing the Wi-Fi SETUP button on the rear of the hub, connect the AC adaptor to the hub.
Do not release the button yet.
3
Continue to hold the Wi-Fi SETUP button down until the hub sounds a short beep, then release the
button.
R The hub's LED indicator blinks in green and yellow.
4
Wait for the hub's LED indicator to start blinking in green.
5
Press and hold the hub's Wi-Fi SETUP button until the LED indicator blinks slowly (about 3 seconds).
6
Within 2 minutes, activate your wireless router's WPS mode (e.g., press and hold its WPS button,
etc.).
7
Wait for the hub's LED indicator to light in green.
R Initial setup is now complete.
8
Register your mobile device to the hub ( "Registering other mobile devices to the hub", Page 28).
Refer to the following after checking the general troubleshooting information described in "General
information", Page 105.
[Device is in use.] is displayed
R Another user (i.e., mobile device) is already accessing the hub, the same screen, or the same feature.
→Wait for the other user to finish and then try again.
[Hub is busy.] is displayed
R Another event, such as a sensor detection or a landline call being received, interrupted the current
operation.
→Wait and try again later.
[This setting is only available when this mobile device is connected to the same Wi-Fi Home
Network as the hub.] is displayed
R While away from home (i.e., while your mobile device was not connected to the same wireless router
as the hub), you tried to access settings that are only available while at home.
→Try again when at home.
[The hub is not receiving a signal.] is displayed
R The hub cannot receive a signal from the device you are trying to operate.
→Make sure the device is receiving power, or that its batteries have adequate charge remaining.
→Move the device closer to the hub or, if possible, remove any obstacles between the device and the
hub.
[Time out] is displayed
R While operating a system feature, you paused for a length of time without performing any actions.
108