Voice Settings Configuration
Field
Attn Transfer Serv
Unattn Transfer Serv
MWI Serv
VMWI Serv
Speed Dial Serv
Secure Call Serv
Referral Serv
Feature Dial Serv
Service Announcement Serv
Reuse CID Number As Name
CONFCID Serv
Description
Enable Attended Call Transfer Service. Three Way Conference is
required for Attended Transfer.
Default setting: yes
Enable Unattended (Blind) Call Transfer Service.
Default setting: yes
Enable MWI Service. MWI is available only if a Voice Mail Service is
set-up in the deployment.
Default setting: yes
Enable VMWI Service (FSK)
Default setting: yes
Enable Speed Dial Service.
Default setting: yes
Secure Call Service. If this feature is enabled, a user can make a secure
call by entering an activation code (*18 by default) before dialing the
target number. Then audio traffic in both directions is encrypted for the
duration of the call.
Default setting: yes
Star codes are set in Vertical Service Activation Codes. To enable secure
calling by default, without requiring a star code, set the user's Secure
Call Setting to yes. See
Enable Referral Service. See the Referral Services Codes parameter in
Vertical Service Activation Codes, on page 63
Default setting: yes
Enable Feature Dial Service. See the Feature Dial Services Codes
parameter in
information.
Default setting: yes
Enable Service Announcement Service.
Default setting: no
Use the Caller ID number as the caller name.
Default settings: yes
Enable Caller ID during conference call.
Default settings: yes
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
Supplementary Service Subscription
User 1 and User 2, on page
Vertical Service Activation Codes, on page 63
88.
for more information.
for more
83