Reboot device by command.
%May
6 15:31:09:734 2010 HP DEVM/5/SYSTEM_REBOOT: System is rebooting now.
# After IRF 2 starts up, it re-joins IRF 1. You can use the display irf topology command to view the
topology information of the IRF fabric.
<Sysname> display irf topology
-------------------------------------------------------------------------
Switch
1
2
3
4
Switching the operating mode of IRF member switches from IRF
to standalone
Network requirements
As shown in
Switch the operating mode of Device A and Device B from IRF to standalone.
Figure 18 An IRF fabric
GE1/4/0/2
Device A
Configuration considerations
Disconnect IRF connections. Unplug cables for the IRF connections or shut down all physical IRF
•
ports on the master at the CLI. This example uses the latter method.
After the IRF fabric is partitioned, switch the operating mode of the two member switches from IRF
•
to standalone.
Configuration procedure
Identify the master.
1.
<IRF> display irf
IRF-Port1
Link
neighbor
UP
3
UP
1
UP
4
UP
2
Figure
18, Device A and Device B are member switches of an IRF fabric.
Device C
GE4/0/1
GE4/0/2
IRF
XGE1/3/0/1
XGE2/3/0/1
(IRF-port1/2)
(IRF-port2/1)
Topology Info
IRF-Port2
Link
neighbor
UP
2
UP
4
UP
1
UP
3
IP network
GE2/4/0/2
Device B
53
Belong To
00e0-fc0f-8c0f
00e0-fc0f-8c0f
00e0-fc0f-8c0f
00e0-fc0f-8c0f