Configuration Procedures; Displaying And Maintaining An Irf Fabric - HP A7503 Configuration Manual

Configuration procedures

Scenario I: Member switch 1 has one MPU, and it is corrupted. Member switch 2 has two MPUs.
•
Modify the member ID of the standby MPU on member switch 2 to make it consistent with that of
1.
member switch 1.
Unplug the corrupted MPU on member switch 1, and insert the standby MPU of member switch 2
2.
into member switch 1.
Configure IRF ports on member switch 1, and connect member switch 1 to member switch 2
3.
through physical IRF ports.
The fast recovery is completed.
• Scenario II: Both member switches have only one MPU, and the MPU on member switch 1 is
corrupted.
Insert another MPU into member switch 2 and use it as the standby MPU of member switch 2.
4.
Copy the configuration file a.cfg on the active MPU of member switch 2 to the standby MPU, and
5.
set the file as the startup configuration file.
Modify the member ID of the standby MPU on member switch 2 to make it consistent with that of
6.
member switch 1.
Unplug the corrupted MPU on member switch 1, and insert the standby MPU of member switch 2
7.
into member switch 1.
Configure IRF ports on member switch 1, and connect member switch 1 to member switch 2
8.
through physical IRF ports.
The fast recovery is completed.
Follow the step below to modify the member ID of the standby MPU:
To do...
Enter system view
Change the member ID of the
standby MPU

Displaying and maintaining an IRF fabric

To do...
Display information about the IRF
fabric
Display topology information
about the IRF fabric
Display all members'
configurations that take effect after
device reboots
Use the command...
system-view
In IRF mode:
set irf chassis chassis-number slot
slot-number member-id member-id
In standalone mode:
set irf slot slot-number member-id
member-id
Use the command...
display irf [ | { begin | exclude |
include } regular-expression ]
display irf topology [ | { begin |
exclude | include }
regular-expression ]
display irf configuration [ | { begin
| exclude | include }
regular-expression ]
33
Remarks
—
This command is only
applicable to the fast
recovery of the IRF. Using
this command in other cases
may cause unknown errors.
Use it with caution.
Remarks
Available in any view
Available in any view
Available in any view