Follow these steps to modify a member ID for a member switch:
To do...
Enter system view
Modify a member ID for a
member switch
CAUTION:
Member ID changes take effect at the reboot of the switch.
•
•
Change member IDs for the switches in an IRF fabric with caution. The change might cause
configuration change and even data loss.
Different switch models and cards have different requirements for member IDs. See "Setting a member
•
ID for the switch."
Specifying a priority for a member switch
Follow these steps to specify a priority for a member switch:
To do...
Enter system view
Specify a priority for a member of
an IRF fabric
Configuring IRF ports
After an IRF fabric is formed, you can add physical ports used to connect member switches.
Follow these steps to configure IRF ports:
To do...
Enter system view
Enter physical IRF port view
Shut down the port
Return to system view
Create an IRF port and enter IRF
port view
Use the command...
system-view
irf member member-id renumber
new-member-id
Use the command...
system-view
irf member member-id priority priority
Use the command...
system-view
interface interface-type
interface-number
shutdown
quit
irf-port member-id/port-number
21
Remarks
—
Optional
The switch has no default ID in
standalone mode. After it
switches to the IRF mode, it uses
the member ID pre-configured in
standalone mode by default.
Remarks
—
Optional
The priority of a member defaults
to 1.
Remarks
—
—
Required
—
—