Getting The Printer Ready; Inserting The Label Roll - Honeywell PC42t User Manual

SPO
Legend (Figure 2):
1 – Ethernet port
2 – Serial port (RS232)
3 – USB device port
4 – USB host port for external devices (NOT intended to use for connecting with the PC)
5 – Power port
6 – External media feed slot (for wider label rolls)
2.3

Getting the printer ready

2.3.1

Inserting the label roll

1. Open the printer cover and insert the holder into the label roll. Then, insert the holder into
the compartment. Raise the ribbon mechanism. Feed the label roll through the side guides
behind the sensor.
2. When inserting the label roll, check the positioning of the
label sensor in front of the guides. For printing labels, it
should be aligned with the left triangle, as pictured.
3. If you do not need to insert the ribbon, close the mechanism.
Push on the mechanism from above until it clicks into place.
© IZUM, 6. 3. 2018, SPO-NA-EN-316, V1.0
HONEYWELL PC42t User Guide
3/13