Advertisement
The keypad is designed to control the DOMONIAL panel series. It features a proximity tag
reader and an integrated siren for deterrent action and is used to arm and disarm your
security system.
FEATURES
Total Setting (①) / Part Setting (②) / Annex Setting (key "7" + key "9")
Unsetting via code or Tag (③)
Panic Alert (SOS): push ④+⑤ simultaneously
4 Status LEDs to indicate system status/faults (⑥)
"Ghost Light" LEDs to light the keypad during operation
Siren (⑦)
Tag Reader (⑧)
MOUNTING
The keypad must be installed on its mounting bracket and is not meant to be used outside
its bracket. This bracket must be fixed on a wall and easily accessible for the arming and
disarming of the system.
Mounting steps:
1) Separate the bracket (⑨) from the keypad (⑩)
2) Fix the bracket on the wall using 3 screws (⑪)
3) Remove the plastic strips to power the keypad (⑫)
4) Put the keypad back in its bracket (⑬)
5) Secure the keypad in its bracket with the supplied screw (⑭)
REGISTRATION
The registering is the procedure associating the keypad to the panel. This operation
requires a programming tool. The complete procedure is described in the alarm central
unit installation notice or in the programming tool manual.
Up to 4 keypads of this type can be used per installation.
1) Connect the programming tool and start programming.
2) Go to the « Register » menu and put the panel into registration mode.
3) To register the keypad remove the keypad from its mounting bracket and insert it again
to generate a radio pulse (tamper) or trigger an alert by pressing simultaneously
and
(⑤) keys.
The keypad will beep during the time between tamper/alert activation and the confirmation
by the panel.
4) Configure the keypad in the programming tool:
- Set label of the device
- Choose alert mode (1: silent, 2: beep or 3: siren)
- Choose associated set (Total only, Annex only, Total + Annex)
5) Exit programming mode.
INSTALLATION INSTRUCTIONS
(④)
Advertisement
