Table of Contents
Advertisement
The POWER light does not blink when I press the
• Check the device is on.
• Press the
RESET / ENC RYPT
seconds.
• The POWER light on some powerline devices do not blink as part of the ENCRYPT process. Check your
powerline device is a PLA.
The POWER light blinks two times quickly then pauses, before repeating.
The ENCRYPT process has failed. Press the
then try to reconnect.
The POWER lights on both devices blink when I press the
HomePlug light does not turn on.
• Ensure you have pressed the
• Wait for about a minute while the devices set up a connection.
• If that does not work, try again with both devices connected to a power strip next to each other. If
they now connect, then the devices were not on the same electrical circuit before.
The POWER lights on both devices blink, then many lights blink and the HomePlug light blinks red.
Do not worry, the connection process is proceeding normally.
The POWER lights on both devices finished blinking, but only one device's HomePlug light is on.
One device may have connected to a third powerline device. To check device A is connected to
device B and not another device, disconnect device B from its power source. Device A's HomePlug
(
) light will turn off if the connection is with Device B. Press the
for 5 to 8 seconds, then try to reconnect, pressing the
devices.
I pressed the RESET/ENCRYPT button for 5 to 8 seconds, but the HomePlug light is still on.
Chapter 12 Troubleshooting
RESET / ENC RYPT
button again, making certain you have pressed the button for 0.5 to 3
RESET / ENC RYPT
button on both devices.
RESET / ENC RYPT
PLA5236 User's Guide
66
button.
button on both devices for 5 to 8 seconds,
buttons, but the
RESET / ENC RYPT
RESET / ENC RYPT
button for 0.5 to 3 seconds on both
RESET / ENC RYPT
button on both devices
Advertisement
Table of Contents
