Cisco GLC-FE100FX Maintenance And Troubleshooting Manual page 15

10GE 1/1
Active
10GE 1/2
Active
10GE 2/1 N/A
10GE 2/2 N/A
If only GE ports are selected for uplink:
Slot 1:
Supervisor II
Uplink
Plus 10GE or
Interface
V 10 GE Slot
2: Empty
GE 1/3
Active
GE 1/4
Active
GE 1/5
Active
GE 1/6
Active
GE 2/3 N/A
GE 2/4 N/A
GE 2/5 N/A
GE 2/6 N/A
If both 10GE and GE ports are selected for uplink:
Slot 1:
Supervisor II
Uplink
Plus 10GE or
Interface
V 10 GE Slot
2: Empty
10GE 1/1
Active
10GE 1/2
Active
10GE 2/1 N/A
10GE 2/2 N/A
GE 1/3
Active
GE 1/4
Active
GE 1/5
Active
GE 1/6
Active
GE 2/3 N/A
GE 2/4 N/A
GE 2/5 N/A
GE 2/6 N/A
Issue these commands in order to enable the 10-Gigabit Ethernet and/or the Gigabit Ethernet SFP uplink
ports:
Switch#conf t
Switch(config)#hw-module uplink select {tengigabitethernet|gigabitethernet|all}
Refer to the Deploying 10-Gigabit Ethernet and a Gigabit Ethernet SFP Ports
Series Switch Cisco IOS Software Configuration Guide for more information.
SPF Ports of the WS-X4506-GB-T Module or the WS-X4948 Chassis Do Not Come Up
The WS-X4506-GB-T module has six ports. These ports are dual-mode capable ports. Each port has one
RJ45 based 10/100/1000 Mbps connector and one SFP connector. At a given time, only one of these
N/A
Active
N/A Not Active
Active Active
Not Active
Active
Slot1:
Slot 1:Empty Supervisor II
Slot2: Plus 10GE or
Supervisor II V 10 GE Slot2:
Plus 10GE or Supervisor II
V 10 GE Plus 10GE or
V 10 GE
N/A
Active
N/A
Active
N/A Not Active
N/A Not Active
Active Active
Active Active
Not Active
Active
Not Active
Active
Slot1:
Slot 1:Empty Supervisor II
Slot2: Plus 10GE or
Supervisor II V 10 GE Slot2:
Plus 10GE or Supervisor II
V 10 GE Plus 10GE or
V 10 GE
N/A
Active
N/A Not Active
Active Active
Not Active
Active
N/A
Active
N/A
Active
N/A Not Active
N/A Not Active
Active Active
Active Active
Not Active
Active
Not Active
Active
section of the Catalyst 4500