NEC QX-S6648XP-6Q Installation Manual page 82

Installation Guide
QX-S6600 Series Ethernet Switches
3. Set XMODEM protocol parameters
0. Return to boot menu
Enter your choice(0-3):
2) Enter 1 to set the TFTP parameters.
Load File name :update.ipe
Server IP address :192.168.0.3
Local IP address :192.168.0.2
Subnet Mask :255.255.255.0
Gateway IP Address :0.0.0.0
Load File Name
Server IP Address
Local IP Address
Subnet Mask
Gateway IP Address
 NOTE:
To use the default setting for a field, press Enter without entering any value.

If the switch and the server are on different subnets, you must specify a gateway

address for the switch.
3) Enter all required parameters, and enter Y to confirm the settings. The following
prompt appears:
Are you sure to download file to flash? Yes or No (Y/N):Y
Enter Y to start downloading the image file. To return to the Boot menu, enter N.
4)
Loading......................................................................
.............................................................................
.............................................................................
................................................................Done!
Enter the M (main), B (backup), or N (none) attribute for the images. In this example,
5)
assign the main attribute to the images.
Table 6-2 TFTP parameter description
Item
Name of the file to download (for example, update.ipe).
IP address of the TFTP server (for example, 192.168.0.3).
IP address of the switch (for example, 192.168.0.2).
Subnet mask of the switch (for example, 255.255.255.0).
IP address of the gateway (in this example, no gateway is required
because the server and the switch are on the same subnet).
Description
6-16
6 Upgrading software