Cisco EX90 Installation Manual page 2

3
Optional: Mounting the handset
Tool: Screwdriver
A B
Take the touch screen and the handset Fasten the two units together. The screws
base and hold the two units in an upright are pre–mounted in the handset base.
position.
Use the screwdriver and fasten the screws at the
Move the two units together. Make sure the handset base from the underneath.
protruding contact on the handset base slides into
the corresponding hole on the touch screen.
Touch
screen
Handset
base
C
Connect the handset to the handset
base, and connect the handset cable.
4
System overview and basic setup
Remove the cover
to get access to the
connectors at the
rear side.
Kensington lock Micro-
phone
Optional PC For future Optional Optional PC
connection use HDMI output video input
Local area Touch screen Optional
network (LAN) HDMI input
5
Connecting a PC
Optional
PC connection,
RJ45
The optional PC connection
If you have a single LAN wall outlet only, you may
connect your PC to the PC-socket of EX90. Your PC
and the EX90 will then share the LAN connection.
6
Starting the system
Headset 2 x USB
LED
• Steady amber color when
the system is in a call.
• Blinking when incoming/
Scale 1:1
outgoing call and when
Scale 1:1
booting.
Optional PC
audio input
LED
• Steady green color when the
system is in use.
• Blinking when in standby.
Power supply
• Blinks once when the touch button
(use the supplied
is pressed, to indicate registered
AC adapter)
activity.
Video from PC, Audio from PC,
DVI-I cable Stereo cable
3.5 mm mini jack
Cables
The cables are found in the long rectangular box,
see the previous page.
Scale 1:1
Camera
• Turn to open/close
the privacy cover.
• Tilt downwards to
use as document
camera.
On/Off touch button
• Tap the touch button once to
turn on/off the monitor.
• Press gently and hold the touch
button to shut down the system.