Makita HS7000 Instruction Manual page 7

1
► 1 . Clamping screw
For HS7000
Loosen the front and rear clamping screws. Set for the
desired angle (0°-45°) by tilting accordingly, then tighten
the front and rear clamping screws securely.
For HS7600
Loosen the clamping screw. Set for the desired angle
(0°- 45°) by tilting accordingly, then tighten the clamping
screw securely.
Sighting
For HS7000
2
► 1 . Cutting line (0° position) 2. Cutting line (45°
position)
For HS7600
► 1 . Cutting line (0° position) 2. Cutting line (45°
position)
For straight cuts, align the 0° position on the front of the
base with your cutting line. For 45° bevel cuts, align the
45° position with it.
Switch action
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
1
1
► 1 . Switch trigger 2. Lock-off button/ Lock button
For tool with lock-off button
CAUTION:
• Do not pull the switch trigger hard without press-
ing in the lock-off button. This can cause switch
breakage.
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, depress the lock-off button and pull the
switch trigger. Release the switch trigger to stop.
7 ENGLISH
2
2
1