Port Fastethernet Spa Leds - Cisco 12000 Series Hardware Installation Manual

8-Port FastEthernet SPA LEDs

The 8-Port FastEthernet SPA has two types of LEDs: an A/L LED for each individual port and a STATUS
LED for the SPA, as shown in
1
Table 2-9
Table 2-9
STATUS
8-Port FastEthernet SPA Cables, Connectors, and Pinouts
The interface connectors on the 8-Port FastEthernet SPA are eight individual RJ-45 receptacles. You can
use all eight interface connectors simultaneously. Each connection supports IEEE 802.3 and Ethernet
10/100BASE-T interfaces compliant with appropriate standards. Cisco Systems does not supply
Category 5 unshielded twisted-pair (UTP) RJ-45 cables; these cables are available commercially.
Figure 2-6
1
A/L A/L
A/L (Active/Link) LED
describes the 8-Port FastEthernet SPA LEDs.
8-Port FastEthernet SPA LEDs
Off
Green
Amber
Off
Green
Amber
In this case, port number refers to the numbered LEDs on the 8-Port FastEthernet SPA (0, 1, 2, 3, 4, 5, 6 or 7). Each LED
number on the 8-Port FastEthernet SPA references a port on the SPA.
shows the RJ-45 connector.
Figure 2-5.
A/L A/L
2 STATUS LED
Off Port is not enabled.
On Port is enabled and the link is up.
On Port is enabled and the link is down.
Off SPA power is off.
On SPA is ready and operational.
On SPA power is on and good, and the SPA is being
configured.
A/L A/L A/L A/L
2