Cisco CPS-MSP-1RU-K9 User Manual page 21

Chapter 2 Setting Up and Maintaining the Multiservices Platform Series Device
Placing the Multiservices Platform Series Device in the Rack
To place the Multiservices Platform Series device in a rack, see
that follows.
Figure 2-6
2
1
Procedure
Confirm that the inner and outer rack rails are properly installed on the Multiservices Platform Series
Step 1
device and on the rack.
Pull the middle rail out from the front of the outer rail until the ball-bearing shuttle is at the front locking
Step 2
position of the middle rail.
Align the inner rails that are attached to the Multiservices Platform Series device with the front of the
Step 3
middle rails that are attached to the rack.
OL-21838-03
Placing the Server in a Rack
Ball-bearing shuttle
Setting up a Multiservices Platform Series Device
1
2 Screws
Cisco Physical Security Multiservices Platform Series User Guide
Figure 2-6 and perform the procedure
2-9