Memory Installation Steps - Cisco PIX 501 Hardware Installation Manual

Chapter 4 PIX 515/515E

Memory Installation Steps

Complete the following to install additional system memory:
Remove network wires and any cords connecting to the PIX Firewall unit if the unit is rack-mounted.
Step 1
The PIX 515/515E should be removed from the rack and placed on a stable working surface. Ensure that
the unit is unplugged from its power source.
Unpack the items in the memory upgrade kit.
Step 2
Remove the top panel from the PIX Firewall unit. Remove all screws holding the assembly in place.
Refer to
and replace the top panel.
Step 3 Determine the location of your system memory sockets (See
Use the markings on the motherboard to determine the socket numbers. Always install the first memory
Step 4
board into the lowest socket number. Progressively add memory boards into higher numbered sockets.
Figure 4-16 PIX 515 System Memory Location
Note
78-15170-01
"Removing and Replacing the PIX 515/515E Chassis Cover"
Front
Do not install a 64 MB DIMM in the PIX 515. You will not be able to properly replace the top
panel because of the height of a 64 MB DIMM. Operating the PIX Firewall chassis without a top
panel installed may cause damage to the unit.
Installing a Memory Upgrade
for information on how to remove
Figure 4-16).
Cisco PIX Firewall Hardware Installation Guide
4-15