Cisco PIX 501 Hardware Installation Manual page 38

Installing the PIX 515/515E
Figure 4-7
100 Mbps
Note
Figure 4-8
Ethernet 2
Step 3 Connect the inside, outside, or perimeter network cables to the interface ports. Starting from the top left
the connectors are Ethernet 2, Ethernet 3, Ethernet 4, and Ethernet 5. The maximum number of allowed
interfaces is 6.
Note
Cisco PIX Firewall Hardware Installation Guide
4-6
PIX 515/515E Serial Console Cable
FAILOV ER
Link
FDX
10/10 0 ETHE RNET 0
CON SOLE
Console
port (RJ-45)
RJ-45 to
DB-9 or DB-25
serial cable
(null-modem)
If your unit has a four-port Ethernet circuit board already installed, refer to
four-port Ethernet circuit board requires the PIX-515/515E-UR license to be accessed.) If it has
one or two single-port Ethernet circuit boards, refer to
optional circuit board, refer to
information about how to remove and replace the chassis cover install circuit boards.
Four-Port Ethernet Connectors in the PIX 515/515E
Ethernet 5
Ethernet 3
100 Mbps Link
10/100 ETHERNE T 1
Ethernet 4 Ethernet 1
Do not add a single-port circuit board in the extra slot below the four-port circuit board.
"Removing and Replacing the PIX 515/515E Chassis Cover"
FDX 100 Mbps FAILOVER
Link
FDX
10/100 ETHERNE T 0
CONSOLE
Ethernet 0
Chapter 4
Computer serial port
DB-9 or DB-25
Figure
Figure 4-9. If you need to install an
PIX 515/515E
4-8. (The
for
78-15170-01