Cisco DTA50 Quick Reference Manual

IMPORTANT SAFETY INSTRUCTIONS
Notice to Installers
The servicing instructions in this notice are for use by qualifi ed service personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions, unless you are qualifi ed to do so.
Note to System Installer
For this apparatus, the coaxial cable shield/screen shall be
grounded as close as practical to the point of entry of the
cable into the building. For products sold in the US and
C a n a d a , t h i s r e m i n d e r i s p r o v i d e d t o c a l l t h e s y s t e m
installer's attention to Article 820-93 and Article 820-100 of
the NEC (or Canadian Electrical Code Part 1), which provides
guidelines for proper grounding of the coaxial cable shield.
This symbol is intended to alert you that uninsulated voltage
within this product may have sufficient magnitude to cause
electric shock.Therefore, it is dangerous to make any kind of
contact with any inside part of this product.
Ce symbole a pour but d'alerter toute personne qu'un contact
avec une pièce interne de ce produit, sous tension et non
isolée, pourrait être suffisant pour provoquer un choc
électrique. Il est donc dangereux d'être en contact avec toute
pièce interne de ce produit.
1) Read these instructions. Protect the Product from Lightning
2) Keep these instructions. In addition to disconnecting the AC power from the wall outlet, disconnect
the signal inputs.
3) Heed all warnings.
4) Follow all instructions. Verify the Power Source from the On/Off Power
Light
5) Do not use this apparatus near water.
When the on/off power light is not illuminated, the apparatus may still be
6) Clean only with dry cloth.
connected to the power source. The light may go out when the apparatus is
7) Do not block any ventilation openings. Install in accordance
turned off , regardless of whether it is still plugged into an AC power source.
with the manufacturer's instructions.
Eliminate AC Power/Mains Overloads
8) Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers)
that produce heat.
9) Do not defeat the safety purpose of the polarized or
WARNING: Avoid electric shock and fi re hazard! Do not
grounding-type plug. A polarized plug has two blades with
overload AC power/mains, outlets, extension cords, or integral
one wider than the other. A grounding-type plug has two
convenience receptacles. For products that require battery power
blades and a third grounding prong. The wide blade or the
or other power sources to operate them, refer to the operating
third prong are provided for your safety. If the provided
instructions for those products.
plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
Handling Disposable Batteries
10) Protect the power cord from being walked on or pinched
This product may contain disposable batteries. Heed the following warning
particularly at plugs, convenience receptacles, and the
and follow the Battery Safety and Battery Disposal instructions below.
point where they exit from the apparatus.
11) Only use attachments/accessories specified by the
manufacturer.
WARNING: There is danger of explosion if the battery is
12) Use only with the cart, stand, tripod, bracket, or
mishandled or incorrectly replaced. Replace only with the same
table specified by the manufacturer, or sold with
type of battery. Do not disassemble it or attempt to recharge it
the apparatus. When a cart is used, use caution
outside the system. Do not crush, puncture, dispose of in fi re,
when moving the cart/apparatus combination to avoid
short the external contacts, or expose to water or other liquids.
injury from tip-over.
Dispose of the battery in accordance with local regulations and
13) Unplug this apparatus during lightning storms or when instructions from your service provider.
unused for long periods of time.
Battery Safety
14) Refer all servicing to qualified service personnel. Servicing
• Insert batteries correctly. There may be a risk of explosion if the batteries
is required when the apparatus has been damaged in any
are incorrectly inserted.
way, such as a power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen into the • Do not attempt to recharge 'disposable' or 'non-reusable' batteries.
apparatus, the apparatus has been exposed to rain or
• Please follow instructions provided for charging 'rechargeable' batteries.
moisture, does not operate normally, or has been dropped.
• Replace batteries with the same or equivalent type that we recommend.
Power Source Warning
• Do not expose batteries to excessive heat (such as sunlight or fi re).
A label on this product indicates the correct power source for this product. • Do not expose batteries to temperatures above 100°C (212°F).
Operate this product only from an electrical outlet with the voltage and
Battery Disposal
frequency indicated on the product label. If you are uncertain of the type
• The batteries may contain substances that could be harmful to the
of power supply to your home or business, consult your service provider
or your local power company. environment.
• Recycle or dispose of batteries in accordance with the battery
The AC inlet on the unit must remain accessible and operable at all times.
manufacturer's instructions and local/national disposal and recycling
Ground the Product regulations.
• The batteries may contain perchlorate, a known hazardous substance,
WARNING: Avoid electric shock and fi re hazard! If this
so special handling and disposal of this product might be necessary. For
product connects to coaxial cable wiring, be sure the cable system
more information about perchlorate and best management practices
is grounded (earthed). Grounding provides some protection against
for perchlorate-containing substance, see www.dtsc.ca.gov/
voltage surges and built-up static charges.
hazardouswaste/perchlorate
WARNING: Avoid electric shock and fi re hazard! Do
not locate an outside antenna system in the vicinity of overhead
power lines or power circuits. Touching power lines or circuits
might be fatal.
This product may contain a tuner capable of receiving off-the-air
broadcasts.
CAUTION: To reduce the risk of electric shock, do not
remove cover (or back). No user-serviceable parts
inside. Refer servicing to qualified service personnel.
WARNING
TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS UNIT TO RAIN OR MOISTURE.
This symbol is intended to alert you of the presence
of important operating and maintenance (servicing)
instructions in the literature accompanying this product.
Ce symbole a pour but de vous avertir qu'une
documentation importante sur le fonctionnement et
l'entretien accompagne ce produit.
20080814_Installer820
Provide Ventilation and Select a Location
• Remove all packaging material before applying power to the product.
• Do not place this apparatus on a bed, sofa, rug, or similar surface.
• Do not place this apparatus on an unstable surface.
• Do not install this apparatus in an enclosure, such as a bookcase or rack,
unless the installation provides proper ventilation.
• Do not place entertainment devices (such as VCRs or DVDs), lamps,
books, vases with liquids, or other objects on top of this product.
• Do not block ventilation openings.
Operating Environment
This product is designed for operation indoors with a temperature range
from 32° to 104° F (0° to 40°C). Each product should have adequate
spacing on all sides so that the cooling air vents on the chassis are not
blocked.
Protect from Exposure to Moisture and Foreign
Objects
WARNING: Avoid electric shock and fi re hazard! Do not
expose this product to dripping or splashing liquids, rain, or moisture.
Objects fi lled with liquids, such as vases, should not be placed on
this apparatus.
WARNING: Avoid electric shock and fi re hazard! Unplug
this product before cleaning. Do not use a liquid cleaner or an
aerosol cleaner. Do not use a magnetic/static cleaning device (dust
remover) to clean this product.
WARNING: Avoid electric shock and fi re hazard! Never
push objects through the openings in this product. Foreign objects
can cause electrical shorts that can result in electric shock or fi re.
Service Warnings
WARNING: Avoid electric shock! Do not open the cover
of this product. Opening or removing the cover may expose you
to dangerous voltages. If you open the cover, your warranty will be
void. This product contains no user-serviceable parts.
Check Product Safety
Upon completion of any service or repairs to this product, the service
technician must perform safety checks to determine that this product is in
proper operating condition.
Protect the Product When Moving It
Always disconnect the power source when moving the apparatus or
connecting or disconnecting cables.
20110316_Cable_Safety
Cisco DTA50 Digital Transport Adapter
Open Source GNU GPL Statement
Declaration of Conformity
Cisco DTA50 Digital Transport Adaptor contain(s), in part, certain free/open
This device complies with Part 15 of FCC Rules. Operation is subject
source software ("Free Software") under licenses which generally make
the source code available for free copy, modifi cation, and redistribution. to the following two conditions: 1) the device may not cause harmful
interference, and 2) the device must accept any interference received,
Examples of such licenses include all the licenses sponsored by the Free
including interference that may cause undesired operation.
Software Foundation (e.g. GNU General Public License (GPL), GNU Lesser
General Public License (LGPL), Berkeley Software Distribution (BSD), the
MIT licenses and diff erent versions of the Mozilla and Apache licenses). To
fi nd additional information regarding the Free Software, including a copy of
the applicable license and related information, please go to: (i) for North
America http://www.cisco.com/web/consumer/support/open_source.
html, or (ii) for outside North America http://www.cisco.com/web/
consumer/support/open_source.html#~international. Once at the site,
search for the product listing and click on the related items identifi ed. If you
have any questions or problems accessing any of the links, please contact:
spvtg-external-opensource-requests@cisco.com.
United States FCC Compliance
Canada EMI Regulation
This device has been tested and found to comply with the limits for a Class
This Class B digital apparatus complies with Canadian ICES-003.
B digital device, pursuant to part 15 of the FCC Rules. These limits are
Cet appareil numérique de la class B est conforme à la norme
designed to provide reasonable protection against such interference in a
NMB-003 du Canada.
residential installation. This equipment generates, uses, and can radiate
radio frequency energy. If not installed and used in accordance with the
instructions, it may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment
OFF and ON, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit diff erent from that to
which the receiver is connected.
• Consult the service provider or an experienced radio/television technician
for help.
Any changes or modifi cations not expressly approved by Cisco Systems,
Inc., could void the user's authority to operate the equipment.
The information shown in the FCC Declaration of Conformity paragraph
below is a requirement of the FCC and is intended to supply you with
information regarding the FCC approval of this device. The phone numbers
listed are for FCC-related questions only and not intended for questions
regarding the connection or operation for this device. Please contact your Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affi liates in the U.S. and other countries. A listing of Cisco's trademarks can be found at
www.cisco.com/go/trademarks.
service provider for any questions you may have regarding the operation or
installation of this device. Third party trademarks mentioned are the property of their respective owners.
The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1009R)
© 2011, 2012 Cisco and/or its affi liates. All rights reserved.
July 2012
DTA50
POWER
AVC VIDEO LICENSE
With respect to each AVC/H.264 product, we are obligated to provide
the following notice:
THIS PRODUCT IS LICENSED UNDER THE AVC PATENT PORTFOLIO LICENSE
FOR THE PERSONAL USE OF A CONSUMER OR OTHER USES IN WHICH IT
DOES NOT RECEIVE REMUNERATION TO (i) ENCODE VIDEO IN COMPLIANCE
WITH THE AVC STANDARD ("AVC VIDEO") AND/OR (ii) DECODE AVC VIDEO
THAT WAS ENCODED BY A CONSUMER ENGAGED IN A PERSONAL ACTIVITY
AND/OR WAS OBTAINED FROM A VIDEO PROVIDER LICENSED TO PROVIDE AVC
Cisco DTA50 Digital Transport Adapter
VIDEO. NO LICENSE IS GRANTED OR SHALL BE IMPLIED FOR ANY OTHER USE.
ADDITIONAL INFORMATION MAY BE OBTAINED FROM MPEG LA, L.L.C. SEE
Model: DTA50
HTTP://WWW.MPEGLA.COM.
Manufactured by:
Accordingly, please be advised that service providers, content providers,
Cisco Systems, Inc.
and broadcasters are required to obtain a separate use license from MPEG
5030 Sugarloaf Parkway
LA prior to any use of AVC/H.264 encoders and/or decoders.
Lawrenceville, Georgia 30044 USA
Telephone: 678 277-1120
Disclaimer
Cisco Systems, Inc. assumes no responsibility for errors or omissions that
may appear in this guide. We reserve the right to change this guide at any
time without notice.
20081121 FCC Standard
Cisco Systems, Inc.
5030 Sugarloaf Parkway, Box 465447
Lawrenceville, GA 30042
Quick Reference Guide
678 277-1120
800 722-2009
www.cisco.com
Part Number 4025708 Rev C