Step 5: Install An Sfp Transceiver Module - NETGEAR ProSAFE S3300 Hardware Installation Manual

Note: For 10GBASE-T connections, and in particular for connections over
30 meters (about 100 feet), NETGEAR recommends that you use a
Category 6a cable or a cable that is even higher rated.

Step 5: Install an SFP Transceiver Module

The following procedure describes how to install an optional SFP transceiver module into one
of the SFP ports of the smart switch.
Note: Contact your NETGEAR sales office to buy these modules. If you do
not want to install an SFP module, skip this procedure.

To install an SFP transceiver module:
1. Insert the transceiver into the SFP port.
2. Press firmly on the flange of the module to seat it securely into the connector.
You can install up to two additional 10 Gbps or 1 Gbps modules using this procedure.
The following figure shows model S3300-52X-PoE+. However, you install SFP transceiver
modules in the other S3300 models in the same manner.
Figure 13. Installing an SFP transceiver module
S3300 Smart Switch
Installation
28