Table of Contents
Advertisement
3-17 Installing SIMM
1. Before you install SIMM, make sure that printer
power is off, all cables are unpluged. The toner
cartridge is also to be removed.
2. Remove two screws and,pull the PCB controller
Ass'y.
3. Locate the SIMM connector on the control board.
Samsung Electronics
4. Hold the SIMM with the connection points and
insert the SIMM all the way into the connector at
30
o
angle .
5. Push it firmly until it snaps into place.
Make sure both metal clips on the connector are
fastened and the two pins on the connector are
pushed through the holes on the SIMM.
Note: When you disassemble the SIMM, push
out on the metal clips at each end of the
connector and pull it toward you.
6. Reassemble the shield cover.
Disassembly and Reassembly
3-11
Advertisement
Table of Contents
