Cisco TelePresence MX800 Installation Manual page 8

Installation guide for Cisco TelePresence MX800 - Floor stand
3
Read this before you mount the monitor
The monitor is heavy.
We recommend four people working
together to mount the monitor. Two
people should lift the monitor using
the handles as described below; the
other people must help stabilizing
the monitor and check that the
monitor enters the slots properly.
The screws with wing nut, which you
can see from the sides of the monitor,
must enter the center slot on each
side of the floor stand.
78-100219-02A0 | JUNE 2016 | © 2016 Cisco Systems, Inc. All rights reserved.
Use lifting handles
To avoid trapping your fingers, use the
lifting handles at the bottom of the monitor.
Applies to systems that are secured to the
wall: To assure that the camera(s) can move
freely, fasten two bumpons on the rear of the
top profile, close to the camera(s).
Page 8 http://www.cisco.com/go/mx-docs