Connect Cables - Cisco TelePresence MX800 Installation Manual
Single monitor with single/dual camera
on a free standing floor stand or a floor stand secured to the wall
Hide thumbs
Also See for TelePresence MX800:
- Replacement manual (47 pages) ,
- Installation manual (30 pages) ,
- Spare parts (24 pages)
Advertisement
Installation guide for Cisco TelePresence MX800 - Floor stand
6
Connect cables
B, E
Remove any protection foam
from the camera(s). Make sure
the camera(s) can move freely
before connecting power.
Always use the power
cables provided.
The plug-socket
combination must be
accessible at all times,
because it serves as
the main disconnecting
device.
Power (100-240 VAC, 50/60 Hz), extension
cord and country-specific cable.
78-100219-02A0 | JUNE 2016 | © 2016 Cisco Systems, Inc. All rights reserved.
(page 1 of 2)
Codec connector panel
Microphones
(max 8)
Network
1
Video input
e.g. computer
2
Page 11
Route the cables down,
and put them behind the
hooks in the floor stand.
CAT 5e, shielded Ethernet cable, 5 m.
1
Two presentation cables are provided: HDMI ↔ HDMI;
2
and DVI/Euroblock ↔ VGA/mini jack.
http://www.cisco.com/go/mx-docs
Advertisement
