Cisco ASA 5506-X Quick Start Manual page 12

Cisco Firepower Threat Defense for the ASA 5506-X Series Using Firepower Device Manager Quick Start Guide
After issuing the enable command, the system will prompt you for a password. By default, the password is
blank.
Example:
firepower> enable
Password: <by default, the password is blank>
firepower#
3. Enter the command to restore the access point default configuration:
firepower# hw-module module wlan recover configuration
4. See the Cisco IOS Configuration Guide for Autonomous Aironet Access Points
access point CLI.
Access the Wireless Access Point Console (ASA 5506W-X)
You can configure and monitor the wireless access point using the command-line interface (CLI), which you
access from the Firepower Threat Defense CLI (connect to the console port, or configure Telnet or SSH access).
Procedure
1. From the Firepower Threat Defense CLI, navigate to the system support CLI menu:
> system support diagnostic-cli
Example:
> system support diagnostic-cli
Attaching to ASA console ... Press 'Ctrl+a then d' to detach.
Type help or '?' for a list of available commands.
firepower>
2. Enter the enable command to turn on privileged commands:
firepower> enable
After issuing the
blank.
Example:
firepower> enable
Password: <by default, the password is blank>
firepower#
3. Session to the access point:
firepower# session wlan console
Example:
firepower# session wlan console
opening console session with module wlan
connected to module wlan. Escape character sequence is 'CTRL-^X'
ap>
4. See the Cisco IOS Configuration Guide for Autonomous Aironet Access Points
access point CLI.
enable command, the system will prompt you for a password. By default, the password is
7. Configure the Wireless Access Point (ASA 5506W-X)
12
for information about the
for information about the