Table of Contents
Advertisement
Loss of the Security Card
Losing the security card will not compromise system functionality. However, if at some stage in
the future you need further keys you will have to request both a new security card and new keys
from the manufacturer.
The following steps are required once you have received the new security card and keys:
1. Restore the default settings
- see chapter "Restoring the Default Settings"
2. Read in the new security card and keys
- see chapter "Reading In Keys and Programming the System"
Restoring the Default Settings
Restore the default settings as follows:
1. The system is in a disarmed state (e.g. in revision mode).
!
2.
Remove the control unit cover. The plugs with the
LSN lines (3.4 and 7.8) must be removed from the control unit.
3. In the control unit, move the jumper from B1 to B2.
4. Close the tamper contact GK for at least 3 seconds until you hear the buzzer.
All the keys and the customer code have now been erased.
The default settings have been restored.
5. In the control unit, move the jumper from B2 back to B1.
6. Reconnect the plugs with the LSN lines to the control unit and reset the LSN line malfunction
message on the control panel.
Notes for Maintenance and Service
45
Advertisement
Table of Contents
